Fishfinders allow anglers to see a graphic representation of what is beneath their boats so they can identify fish. To choose a fishfinder, consider the type of unit—whether it includes GPS and is part of a boatwide network, size of the fishfinder’s footprint, resolution of the display, how much transmitting power you need, and what frequencies will work best in the inland, coastal or deep-water environment where you fish.
Modern rods are sophisticated casting tools fitted with line guides and a reel for line stowage. They are most commonly made of fibreglass, carbon fibre or, classically, bamboo. Fishing rods vary in action as well as length, and can be found in sizes between 24 inches and 20 feet. The longer the rod, the greater the mechanical advantage in casting. There are many different types of rods, such as fly rods, tenkara rods, spin and bait casting rods, spinning rods, ice rods, surf rods, sea rods and trolling rods.
Fishing with a hook and line is called angling. In addition to the use of the hook and line used to catch a fish, a heavy fish may be landed by using a landing net or a hooked pole called a gaff. Trolling is a technique in which a fishing lure on a line is drawn through the water. Snagging is a technique where the object is to hook the fish in the body.
If you’ve used a fish finder before, then you might be wondering why it’s necessary to get one with a GPS. To be perfectly honest, if you are someone who likes to fish in your local area and either casts from the shore or the back of a small boat, then GPS capability may not be something that’s worthwhile. However, for any fisherman who likes to go searching for the best catch, having GPS installed on your finder can make a world of difference. Here are some of the best reasons to get the best GPS combo fish locator.
If I'm scouting a new area I won't know anything about what sort of structure is ahead until I paddle over it, blowing out any fish that may have been there. With this little guy, I could cast it to the spot, get a read on what's below and proceed. And, you have the luxury of retrieving it slowly to see bottom contours between you and that fishy spot. There have been a number of occasions when I've made numerous casts at a fishy looking location (without any luck), only to paddle over there and discover that it was 10" deep, nobody home.
Fishfinders operate using a single frequency transducer, dual frequencies, multiple frequencies or a broadband CHIRP system. In general, higher frequencies give the finest detail resolution, the least background noise on your screen and the best view from a fast-moving boat, but don’t penetrate as deeply as lower frequencies. Shallow-water inland anglers generally choose higher frequencies of 200kHz, 400kHz or 800kHz. For maximum depth, use lower frequencies. We recommend 200kHz or higher (up to 800kHz) for water depths up to 200' and 80kHz or 50kHz for deeper waters.
The final point to remember when you are looking out for fish arches is that it doesn’t need to be a full arch. Half arches (like the ones shown in the screen shot above) also show that there is fish. In ourtutorial on how sonars work, we explain in detail why sometimes you get a full arch and sometimes you get a half arch. The short answer is that you will get a full arch if a fish swims through the whole of your sonar cone, and a half or partial arch if they only swim through part of it.
The use of the hook in angling is descended, historically, from what would today be called a "gorge". The word "gorge", in this context, comes from an archaic word meaning "throat". Gorges were used by ancient peoples to capture fish. A gorge was a long, thin piece of bone or stone attached by its midpoint to a thin line. The gorge would be fixed with a bait so that it would rest parallel to the lay of the line. When a fish swallowed the bait, a tug on the line caused the gorge to orient itself at right angles to the line, thereby sticking in the fish's gullet.
BABY STEPS: You don't have to spend a ton of money or be an engineer to get your kayak electrified. Here we have the Lowrance X50DS. The fishfinder and the installation kit will run around $250. Look at what you spend for a rod/reel/braided line, and you'll find this kit is certainly affordable. The display is 4-level grayscale, and the battery pack contains AA batteries. However, what it may lack in fashion it makes up by function. The battery pack goes in a dry bag, and the unit itself is easily removed at the end of the day. It features a built in temperature sensor and 120 degrees of wide angle coverage.