If you’ve used a fish finder before, then you might be wondering why it’s necessary to get one with a GPS. To be perfectly honest, if you are someone who likes to fish in your local area and either casts from the shore or the back of a small boat, then GPS capability may not be something that’s worthwhile. However, for any fisherman who likes to go searching for the best catch, having GPS installed on your finder can make a world of difference. Here are some of the best reasons to get the  best GPS combo fish locator.
The final point to remember when you are looking out for fish arches is that it doesn’t need to be a full arch. Half arches (like the ones shown in the screen shot above) also show that there is fish. In ourtutorial on how sonars work, we explain in detail why sometimes you get a full arch and sometimes you get a half arch. The short answer is that you will get a full arch if a fish swims through the whole of your sonar cone, and a half or partial arch if they only swim through part of it.
Whether you're off to a nearby stream for some fly fishing or heading out into the open waters for a deep sea fishing adventure, the right fishing gear will make your trip even more exciting. When the weather's nice, find a quiet spot to cast your line with a new fishing reel. Pick up a rod and reel combo that's ready to go right out of the box or customize your fishing gear with a separate rod and reel.
The size of the area you’re scanning will be affected by the angle of the cone. A wide beam cone scans between 40°-60°, meaning you’ll be covering a large area. A narrow cone will scan between 10°-20°. So make sure you’re aware of whether your fish finder is using a wide or narrow cone when you’re looking at the data on your screen. The Deeper PRO and PRO+ have wide and narrow beam scanning (55° and 15°), the Deeper START has a medium/wide beam (40°). One other point to remember about how you sonar works is that it is constantly sending and receiving data, which means your display will be continually scrolling. The current scanning data will be on the right – the further left on the screen, the older the data.

The power of a fishfinder—the strength of the “ping”—is expressed in watts RMS (root mean squared). Power is directly related to how well you see in silt-laden water, view down to greater depths, and successfully resolve separate targets and bottom structure. A 500-watt (RMS) fishfinder should have plenty of power for most coastal applications. Serious bluewater anglers should look for 1,000 watts or more. Inland lake fishermen can see the shallow bottom with only 200 watts.


* Financing available is "Equal payments, no interest" for 12 months (unless otherwise stated) and is only available on request, on approved credit and on purchases of $200 or more (excluding gift cards) made with your Triangle credit card at Canadian Tire, Sport Chek and participating Marks and Atmosphere locations. Interest does not accrue during the period of the plan. However, if we do not receive the full minimum due on a statement within 59 days of the date of that statement, or any event of default (other than a payment default) occurs under your Cardmember Agreement, all special payment plans on your account will terminate and (i) you will then be charged interest on the balances outstanding on such plans at the applicable regular annual rate from the day after the date of your next statement, and (ii) the balances outstanding will form part of the balance due on that statement. There is no administration fee charged for entering into a special payments plan. Each month during an equal payments plan you are required to pay in full by the due date that month’s equal payments plan instalment. Any unpaid portion not received by the due date will no longer form part of the equal payments plan and interest will accrue on that amount from the day after the date of your next statement at the applicable regular annual rate.
A fishfinder or sounder (Australia) is an instrument used to locate fish underwater by detecting reflected pulses of sound energy, as in sonar. A modern fishfinder displays measurements of reflected sound on a graphical display, allowing an operator to interpret information to locate schools of fish, underwater debris, and the bottom of body of water. Fishfinder instruments are used both by sport and commercial fishermen. Modern electronics allows a high degree of integration between the fishfinder system, marine radar, compass and GPS navigation systems.
You want to turn the fish finder on. It will be set in automatic mode already, with the pre-program settings already on. You can switch it to a manual mode at any time to customized the finder. When you first turn it on, you can leave it in the automatic mode. You then want to drive on the water in automatic mode to get an idea of what it’s seeing.
A fish finder is an incredible tool that can help take your sport or commercial fishing venture to the next level. However, even the best fish finders can use a little improvement – and adding a GPS is one way to do this.The best fishfinder GPS combo will help you navigate whatever body of water you are on at the same time as it allows you to find where to fish more quickly, accurately and efficiently.
The image to the right shows a school of white bass aggressively feeding on a school of threadfin shad. Note the school of baitfish near the bottom. When threatened, baitfish form a tightly packed school, as the individuals seek safety in the center of the school. This typically looks like an irregularly shaped ball or thumbprint on the fishfinder screen. When no predators are nearby, a school of baitfish frequently appears as a thin horizontal line across the screen, at the depth where the temperature and oxygen levels are optimal. The nearly-vertical lines near the right edge of the screen show the path of fishing lures falling to the bottom.
Early sporting fathometers for recreational boating used a rotating light at the edge of a circle which flashed in sync with the received echo, which in turn corresponded to depth. These also gave a small flickering flash for echos off of fish. Like today's low-end digital fathometers, they kept no record of the depth over time and provided no information about bottom structure. They had poor accuracy, especially in rough water, and were hard to read in bright light. Despite the limitations, they were still usable for rough estimates of depth, such as for verifying that the boat had not drifted into an unsafe area.
These sonar reflections will also display on the screen. So this way a fishfinder reads and lets you view the bottom and everything it encounters in between. The angle of the sonar beam is measured in degrees and it’s called the cone angle. A wider angle covers more area underwater. Different fish detector models come with different cone angles. Some models also include multi-beam sonar technology that allows covering a much wider area.

CHIRP fishfinders transmit less peak power than a conventional fishfinder, but their wide-band, frequency modulated pulses (130-210kHz, for example) can be very long in duration and put 10-50 times more energy into the water. Using digital pattern matching and signal processing, CHIRP devices achieve unprecedented resolution and target detection. Your ability to resolve individual fish, or separate fish from bottom structure, is now a matter of inches, instead of several feet with traditional fishfinders. See individual fish in groups, instead of a single mass.
Fish finders were derived from fathometers, active sonar instruments used for navigation and safety to determine the depth of water.[1] The fathom is a unit of water depth, from which the instrument gets its name. The fathometer is an echo sounding system for measurement of water depth. A fathometer will display water depth and can make an automatic permanent record of measurements. Since both fathometers and fishfinders work the same way, and use similar frequencies and can detect both the bottom and fish, the instruments have merged.[2]
The temperature and pressure sensitivity capability of fish finder units allow one to identify the exact location of the fish in the water by the use of a temperature gauge.Functionality present in many modern fish finders also have track back capabilities in order to check the changes in movement in order to switch position and location whilst fishing.
For precise detection of structures and fish, our Raymarine radar bundle gives you remarkable resolution. The Garmin Chartplotter radar combo updates your position 10 times per second to accurately maintain your heading. A large screen with an outstanding LED display on our Humminbird fish finder GPS provides images that are easy to read even in bright sunny conditions. You can find the best marine depth finder GPS combo here, and we stand behind all of our products with a 30-day guarantee against defects. Contact our team of experts if you should need any assistance in finding the products you require.

Kiss has collectable action figures. Does Madonna have action figures? Eh, better not answer that one. Back in the day, I was a member of the Kiss Army. What sort of fan club does Madonna have? Better step away from that one too. Pluto will always be a planet to me, and Kiss is already in *my* rock and roll hall of fame. I love the smell of flamethrowers and flash pots in the morning … smells like … victory.
The sound wave spreads as it gets further from the transducer. The wider the cone, the larger the coverage area, but the as the cone angle spreads, sensitivity diminishes. A 20-degree cone is considered a versatile angle for fishers who frequent different water depths. More advanced devices come with double and triple beams, ideal for scanning deep water depths.
Paddling.net has always given me plenty of room to not only discuss paddle fishing things, but other worldly things as well. So, with colder weather upon us and fewer fishing opportunities available, I figured I might as well take full advantage of that luxury and devote an installment to those "other" things. You know, like politics, religion/faith (the huge difference between them), family, crime/punishment, and why Kiss still isn't in the rock and roll hall of fame.

The image to the right shows a school of white bass aggressively feeding on a school of threadfin shad. Note the school of baitfish near the bottom. When threatened, baitfish form a tightly packed school, as the individuals seek safety in the center of the school. This typically looks like an irregularly shaped ball or thumbprint on the fishfinder screen. When no predators are nearby, a school of baitfish frequently appears as a thin horizontal line across the screen, at the depth where the temperature and oxygen levels are optimal. The nearly-vertical lines near the right edge of the screen show the path of fishing lures falling to the bottom.
Many people prefer to fish solely with lures, which are artificial baits designed to entice fish to strike. The artificial bait angler uses a man-made lure that may or may not represent prey. The lure may require a specialised presentation to impart an enticing action as, for example, in fly fishing. Recently, electronic lures have been developed to attract fish. Anglers have also begun using plastic bait. A common way to fish a soft plastic worm is the Texas rig.
A fishing rod is an additional tool used with the hook, line and sinker. A length of fishing line is attached to a long, flexible rod or pole: one end terminates with the hook for catching the fish. Early fishing rods are depicted on inscriptions in ancient Egypt, China, Greece and Rome. In Medieval England they were called angles (hence the term angling). As they evolved they were made from materials such as split Tonkin bamboo, Calcutta reed, or ash wood, which were light, tough, and pliable. The butts were frequently made of maple. Handles and grips were made of cork, wood, or wrapped cane. Guides were simple wire loops.
×