Our Depth Sounders are designed to mount flush in the dash of your boat. Our friendly user interface, automatic range & sensitivity and proprietary algorithms produce precise readings at speeds in excess of 60 MPH. Say goodbye to the days of not knowing the depth while running your boat on plane. Our Hand Held Depth Finders takes portable sonar systems to a whole new level. Get precise readings on the go with just a press of a button.
2-4 PERSON CAPACITY: Comfortably sized 2-4 people capacity including set-up dimensions of 81" x 71" and 71" high with plenty of room to fish and even stand up inside of.|POP-UP STYLE SETUP: Sets up super quick and tears down just as easily by simply pulling up on the roof and then on all four sides so youÆll be good to go in minutes.|FULLY INSULATED FABRIC: Features 300 denier insulated oxford fabric with frost-resistance up to 22 degrees Fahrenheit to keep you warm no matter the weather.|DURABLY DESIGNED: Includes solid fiberglass poles, diecast hubs, and heavy duty zippers designed for repeated use plus 4 strong ground stakes and 4 pull ropes.|WELL-VENTILATED ACCESS: Two zippered doors on opposite ends and hook and loop fastened windows allow for easy access and provide a well-ventilated.
For deep-water fishermen, and those who spend much of their time angling in open water, a GPS is essential. When you are far from landmarks and familiar sight-lines, your chances of success can be much better when you can return to that favourite spot. Commercial-fishing pros understand this as well as anyone, which is why they invest in quality GPS equipment.

Standalone fishfinder: If you just want to see what’s below, dedicated fishfinders give the biggest display and the most performance for the least cost. If you have a small boat that you use for fishing small inland lakes or are on a limited budget, a standalone fishfinder is for you. Conversely, if your pilothouse has room for multiple displays, or if you just bought a new GPS, get a serious big-screen fishfinder. You can usually add a GPS sensor later to many units, turning them into chartplotter combos.
The final point to remember when you are looking out for fish arches is that it doesn’t need to be a full arch. Half arches (like the ones shown in the screen shot above) also show that there is fish. In ourtutorial on how sonars work, we explain in detail why sometimes you get a full arch and sometimes you get a half arch. The short answer is that you will get a full arch if a fish swims through the whole of your sonar cone, and a half or partial arch if they only swim through part of it.
Setting your tip-up baits at the proper depth requires a little work. Then every time you catch a fish or check your bait, you need to reset them. If you’ve got a few nickel-size buttons, those resets become no chore at all. Start by running your main line through one hole in the button and out another. This should allow you to move the button up and down the line easily, but provide enough tension to stop it from sliding on its own. Next, attach your egg sinker, barrel swivel, leader, and hook to the line. Once your depth is set, simply slide the button down to the water’s surface, and then reel the button up to the tip-up’s line guide. Now every time you reset your line after catching a fish or changing bait, wind the spool until the button is at the tip-up guide. Your bait will be set in the same place within the water column every time.

Bright 10” Sunlight Viewable, Touchscreen Display. Garmin’s GPSMAP 7610xsv with 10Hz High Sensitivity GPS Receiver, Preloaded Coastal and Lake Mapping and Wi-Fi is a top choice combination unit for any mariner. New features to the 7610xsv include FLIR Camera Support, Smart Boundaries, and More.HD-ID Sonar, 1kW CHIRP, CHIRP DownVu and CHIRP SideVu built-in. Transducer Required and Sold Separately.


* Financing available is "Equal payments, no interest" for 12 months (unless otherwise stated) and is only available on request, on approved credit and on purchases of $200 or more (excluding gift cards) made with your Triangle credit card at Canadian Tire, Sport Chek and participating Marks and Atmosphere locations. Interest does not accrue during the period of the plan. However, if we do not receive the full minimum due on a statement within 59 days of the date of that statement, or any event of default (other than a payment default) occurs under your Cardmember Agreement, all special payment plans on your account will terminate and (i) you will then be charged interest on the balances outstanding on such plans at the applicable regular annual rate from the day after the date of your next statement, and (ii) the balances outstanding will form part of the balance due on that statement. There is no administration fee charged for entering into a special payments plan. Each month during an equal payments plan you are required to pay in full by the due date that month’s equal payments plan instalment. Any unpaid portion not received by the due date will no longer form part of the equal payments plan and interest will accrue on that amount from the day after the date of your next statement at the applicable regular annual rate.
Whether it is radically changing the way you enjoy your favorite pastime with our game changing marine technology, or reinventing our current product line, we relentlessly pursue innovation in all aspects of our business. At NorCross, Customer Focused Innovation is not just some fancy corporate slogan, it is the foundation of every product and service that we offer. We strive to keep our marine electronics exactly what you need whether that is on the shoreline or in your kayak.

Fishfinders operate using a single frequency transducer, dual frequencies, multiple frequencies or a broadband CHIRP system. In general, higher frequencies give the finest detail resolution, the least background noise on your screen and the best view from a fast-moving boat, but don’t penetrate as deeply as lower frequencies. Shallow-water inland anglers generally choose higher frequencies of 200kHz, 400kHz or 800kHz. For maximum depth, use lower frequencies. We recommend 200kHz or higher (up to 800kHz) for water depths up to 200' and 80kHz or 50kHz for deeper waters.


Other devices which are widely used as bite indicators are floats which float in the water, and dart about if a fish bites, and quiver tips which are mounted onto the tip of the fishing rod. Bite alarms are electronic devices which bleep when a fish tugs a fishing line. Whereas floats and quiver tips are used as visual bite detectors, bite alarms are audible bite detectors.
PERMANENT INSTALLATION: I say an installation is permanent once you start drilling holes. A permanent installation will require you to provide power/wiring, physically mount the transducer, and mount the fish finder itself. A few years ago, these things were a lot tougher to do - similar to baking a cake from scratch. I don't like the notion of "trial and error" when I have a drill in my hand. But now that our sport has become more mainstream, products are being offered specifically for kayaks, and fish finder installation can be so easy, even Betty Crocker could do it.
A GPS also gives you navigation through the waters. For this you will need to select a unit that comes with background maps and charts. One more benefit of the addition of the GPS is safety. Wherever you fish, you will have the confidence that at the end of the day the GPS will easily point you home. For example, you could be fishing throughout different locations during the day, or you could lose sight of land, or some severe weather could suddenly roll out. In such situations, a GPS will give you the exact direction to your home and will tell you how far it is.

Fishfinders operate using a single frequency transducer, dual frequencies, multiple frequencies or a broadband CHIRP system. In general, higher frequencies give the finest detail resolution, the least background noise on your screen and the best view from a fast-moving boat, but don’t penetrate as deeply as lower frequencies. Shallow-water inland anglers generally choose higher frequencies of 200kHz, 400kHz or 800kHz. For maximum depth, use lower frequencies. We recommend 200kHz or higher (up to 800kHz) for water depths up to 200' and 80kHz or 50kHz for deeper waters.

Another great feature of the Elite-5X HDI is the Downscan Overlay that combines traditional sonar with Downscan. Downscan’s primary purpose is finding structure, but it can’t very accurately spot individual fish. That is better done by sonar. Combining the two in one, this device displays on one screen both bottom and structure. So you can see every rock and submerged object as well as fish.
Standalone fishfinder: If you just want to see what’s below, dedicated fishfinders give the biggest display and the most performance for the least cost. If you have a small boat that you use for fishing small inland lakes or are on a limited budget, a standalone fishfinder is for you. Conversely, if your pilothouse has room for multiple displays, or if you just bought a new GPS, get a serious big-screen fishfinder. You can usually add a GPS sensor later to many units, turning them into chartplotter combos.

The temperature and pressure sensitivity capability of fish finder units allow one to identify the exact location of the fish in the water by the use of a temperature gauge.Functionality present in many modern fish finders also have track back capabilities in order to check the changes in movement in order to switch position and location whilst fishing.


There is not much that is more relaxing than spending a beautiful day out fishing in your boat. One thing that may make the day even better is a fish finder GPS, so you do not go home without some delicious fish for dinner. On eBay, reliable sellers offer a broad range of new and used fish finders for you to choose from, including brands like Garmin, Lowrance, Eagle, and Hummingbird. With your new color GPS fish finder, you can enjoy a full color display, along with features that may include screenshots, fish and depth alarms, zoom, and dual imaging. The Garmin 546S Marine GPS find finder, for example, features a chart plotter, sonar, an anchor alarm, sunrise and sunset calculator, and marine cartography software included. No matter which fish finder GPS you decide upon, feel confident that you are receiving high-quality products and convenient shipping options that will ensure that your order makes it to you quickly.

THE LIMBO: How low can you go? Or, how low do you need to go? This is an important question you need to answer. If you don't need to see what's 1000 feet below you, they you can certainly save yourself some money. You did save the gift receipts for those much_appreciated_but_unwanted Christmas gifts, didn't you? Before we take the drill off the charger, let's ponder some options and then work backwards to determine what your needs/wants/limitations are.

Fish finders are incredibly valuable tools, and the more you learn about how to read them, the more successful your fishing trips will be. A key part of learning as angler is to go from trial and error to a more knowledge-based approach. Maybe you regularly catch at a certain spot with a certain presentation – but do you know why? A fish finder will help you understand not just your failures, but also your successes. And once you know this, you can recreate this success more easily.


It terms of the functionality, the HDS-7 is able to connect to the internet to broadcast data, update to new software, upload information such as marked coordinates and more. This Lowrance model uses the latest of advanced technologies such as CHIRP sonar, Broadband sounder, StructureScan HD, DownScan imaging and Trackback view for the ultimate fish finding experience.

Having a GPS onboard is something I've wanted for a while, so that makes the Humminbird 385CI a powerful combo to me. I love "jungle fishing", getting back in mangroves and other areas that are loaded with structure. It's also easy to get turned around in those areas because if you're concentrating on fishing it's easy to lose track of where you are, where you've been, and how to get back to the launch. Obviously, this will help. Between having built in navigational charts and doing your own recon concerning tides for the day, you can make better choices as to where you want to fish.
If you’ve used a fish finder before, then you might be wondering why it’s necessary to get one with a GPS. To be perfectly honest, if you are someone who likes to fish in your local area and either casts from the shore or the back of a small boat, then GPS capability may not be something that’s worthwhile. However, for any fisherman who likes to go searching for the best catch, having GPS installed on your finder can make a world of difference. Here are some of the best reasons to get the  best GPS combo fish locator.
Modern lines are made from artificial substances, including nylon, polyethylene, dacron and dyneema. The most common type is monofilament made of a single strand. Anglers often use monofilament because of its buoyant characteristics and its ability to stretch under load. Recently alternatives such as fluorocarbon, which is the least visible type, and braided fishing line, also known as 'superlines' because of their small diameter, minimal amount of stretch, and great strength relative to standard nylon monofilament lines.
×